Barco Lighting Systems TechnoArc Manual de usuario Pagina 81

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 98
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 80
CHAPTER 5
General Maintenance and Troubleshooting
intellaspot
TM
XT-1 User Manual 67
Replacing a Motor Driver Board
When changing a board, align the screw holes and standoffs to ensure correct orientation in the
fixture. To replace a 2-phase driver board:
1. After remove the bezel and electronic housing cover if applicable, Use a 3 mm allen wrench to
remove the addressing screws and star washers.
2. Position new board against module aligning the center top standoff. Place contact screw(s) in
the appropriate position.
Note: When installing a replacement driver board on a module, always place a
star washer between an address screw and the pad on the logic board
to ensure good electrical contact.
3. Reattach the bezel and retighten captive bezel screws.
Vista de pagina 80
1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 97 98

Comentarios a estos manuales

Sin comentarios